Hi Permies!
I'm in the middle of a building a retaining wall behind the house. I'm a bit late to the idea, considering the stage of the
project, but I am wanting to put a
root cellar in that hill before finishing the retaining wall and regrading the slope above. Then again, the wall is not built, so now is the time if it's going to get done. I'm in Connecticut, zone 6a, with permafrost supposedly at 42", although winters are getting warmer and warmer, and I'm not sure that is accurate anymore.
Would love some feedback from some Permies more experienced in this area than I. Looking for pretty fast feedback as we really need to build that retaining wall soon to avoid the hill sliding down.
It is a SW facing hill, about 8-10' high, but since it is situated right BEHIND a 2 story house, the house essentially shades the "front face" of that hill most of the day. I
should mention that there is a small artesian spring in that hill, so going below grade is not really an option. Curtain drains have already been placed (which will be just under/in front of the retaining wall), and will carry that
water away. I realize it's not ideal being SW facing, but the structure can be built into the hill on 3 sides, and the top, leaving just the front exposed.
To make a cellar 8' wide by 10' deep, here's what I'm thinking to do:
*excavate 16' wide by 16' deep, and 2' below ground level
*lay 2' x 2 x 6' thick
concrete blocks such that they create an interior rectangle 8' wide x 10' deep as a base, with the front of the rectangle, roughly lined up with what will be the front of the retaining wall (allowing a prettier "face" to be put on the blocks)
*curtain drain will be placed around the foundation, to tie in to the existing curtain drain that runs along with the front of the cellar/retaining wall
*cut the blocks for alternate laying of the next layer, leaving a 3' space for door in front
*again, but blocks for alternate laying of the next layer, and again, so as to make 6' high interior walls of the blocks
*to gain another foot of height, and create a top "shelf", 2, 6" blocks will be laid atop those, lined up with the outer edge of the concrete blocks
*fill the base layer with about 2' of
pea stone, to keep it level with the exterior grade
*the top is to be reinforced concrete slab, that will run end to end
*the entire exterior would be treated with sealer, waterproofing, waffle board, etc so as to lead any moisture from the hill, down to the perimeter drain, and those would tie in to the curtain drains, as above
*the slab roof will be flat and covered with sod
*ventilation will be put in, through the bottom half of front door (I expect some contraption that can be inserted to close off cold in winter months), with an exit "chimney" out the back side, near the top and up above the sod
*the front would be faced with
wood, but sandwiching in a 2" insulating foam board between the block and the wood face
*the door would be wood-faced, with a 2" foam, backed with plywood
*I will likely run an outdoor extension cord the short distance from the house to have the ability to have a single pull chain light for convenience when inside, and the potential to run a fan for air circulation.
Is this plan solid? Please poke whatever holes you see in this, and even better, please lay out your best input/ideas on how to make this work better as a functional root cellar, within the confines of the challenges as indicated.
If it's just not going to work trying to build a root cellar at ground level, please give me a head's up, as this is not an inexpensive endeavor.
And if it can't work in the dead of winter, could it be used to extend food storage from harvest up until the hard freeze to give more time for consuming and/or canning, etc, and then be used as an ice house until Spring? Or maybe, with some clerestory windows added to the top of the front face, could I use it better to grow
mushrooms?
If this is hard to "picture", please let me know and I'll sketch it out and try to add the sketches as attachments.
THANKS IN ADVANCE!!