Doug Nevill

Roy Clarke wrote:As a starter for where to look, and what to look for, this has been covered many times.

The principle of the rocket heater is that you burn fuel at high temperature for as long as possible. To get the temperature, you need not to lose heat from the flame, hence the insulation. Now here's the clever, and important bit, when the gases get to the barrel having been got as hot as possible, and having got up the riser driven by the heat, they get cooled by contact with the barrel. As they lose heat and fall in temperature, they drop down the barrel. This is the other half of the heat pump. The heat riser, does what it says on the tin, and makes the gases rise. The barrel cools them and makes them fall down the outside of the riser. This is the power that drives the gases out of the flue.

So that you can have hot gases in the riser, and cooler gases (they will still give you a nasty burn) round the outside, you need (you've guessed it) insulation.

This is in Ianto Evan's book and in several places on this and other forums. Understanding this principle and understanding the need for a huge exit hole from the barrel to the flue are the two bits of knowledge without which a rocket stove will fail to perform.

Thanks for the straight answer, Roy.

I'm ordering the book now.

Doug

Satamax Antone wrote:Doug, read, read and re read, untill you understand things. Order the book of Ianto too. It's clearly explained. I will only say a word, heatsink!

What do you suggest that I read? If you have read the "book of Ianto", does it answer my question - MUST the heat riser / burn chamber / combustion chamber (inside pipe) be insulated or not?

Hi. I am designing a rocket stove thermal mass heater as an insert in my fireplace. From what I have gained from online research, the burn chamber (flue) is always insulated, reason cited is that you want the thing to be hot. My observation is this: it seems it would get even hotter if it was NOT insulated.

Must it be insulated to work and why?