Peter Apalais

My rocket stove/BBQ I can boil 2L of water at about 15deg celsius up to a violent boil in 6mins. From that information can you woek out how much power it has?

Will that then be in BTU's?

No this will be outside in the yard. I want to put a plate on top to use as a BBQ. Then when finished cooking, put on some kind of heat deflector so the hot air blows out sideways where we will be sitting. Not going to use it inside.

Will adding a heat deflector over the top of a rocket stove throw the hot air outwards at all do you think?

I'd like to have a metal hood over the top so the heat will be thrown outwards from the center of the stove.

Does anyone think that this will work? Same as the gas patio heaters you can buy. Except the rocket stove will have the flowing
air which I hope will blow outwards towards us sitting around it.......

I have not yet put a bigger drum over my rocket heater/stove. How hot will the drum get? Will it be good for sitting around at night and getting the heat to keep you warm? or will it not throw out that much heat?

I have been tinkering with a rocket stove. This is the mach 2 version. It is better than the mach 1 version, but is still not what I think it should be like.

I have used some 75x100mm RHS steel that is 6mm thick (1/4" 3"x4").
The height of the chimney is about 750mm.

Now it did burn and got very hot. So hot infact that the inside of the chimney was glowing red/orange, definantly not a dull orange. I guess it was around 600-700 degrees? Which would seem about right because I think it would have melted a soft drink can.

My problem that I have is that to make it burn the best I have to keep scraping out the hot glowing coals all the time. This allows more air to get sucked in.

I was not able to get water to boil, well it had those tiny little bubbles. It did not boil violently.

Interesting though, later on in the night I put a nearly 2" thick x 1 foot long tree branch down the chimney and within about 30seconds I had a massive foot and a half flame roaring out of the top. So I put the pot back on with the water and it
got the water boiling in no time. What a difference that made loading the timber in the chimney.

But, still after that died down I added more wood in the top, but because of the leftover glowing coals it did not have the same effect.


I noticed that the whole metal section was glowing on the inside all the way up until where that bucket is welded on. Now I wonder why it stopped there? I did run out of vermiculite and the top bucket is not filled with anything. Maybe this lack
of insulation did not allow the heat to travel up the metal further?

SO I was thinking to chop off the bucket section as I know it glows read hot just about all the way to the top there. This will give me a chimney length of around 500mm (bucket is 250mm).

This should place the bottom of my pot at a place much hotter than when it was 250mm higher up. So my water might boil there then??



Is a rocket stove meant to have ll those glowing coals at the bottom? Are they supposed to burn out or what?


In the photos you can see.

The overall unit.
The wood feed area and all the coals.

The measurement of the inside diameter of the RHS steel is about 63mm x 89mm

Any thoughts or suggestions to improve it at all.

And how hot should the outside of the drum get? I have it filled with the vermiculite and When it is burning hot you can only hold you hand on it for a second or two. Does that sound about right?

Is there a calculation to workout what internal dimensions of the steel needs to be and what length the chimney height needs to be?

Is chimney height critical?

Peter