Ray Kelly Vargas

Wankel, did you get it to work?  That 12 pin switch looks backward from mine.  Plus square protrusions may prevent switch from mounting properly.  I'm sure I could cut them off.  Since my switch is trashed internally and won't turn I have no way to map connectivity

Looked at that 12 pin switch.  Looks backward from mine with small square protrusions on shaft side.  Not sure it would work.  Problem with mine is internal mechanism is trashed, preventing it from turning, so the timer bypass solution won't work.  Did you get that 12 pin to work?

Having same issue with multi function switch.  There are two plastic tabs on inside of front plate by the shaft of the switch.  Push both tabs in and knob will come off.  Two screws under knob hold switch in place.  I noted wire routing and pulled mine out to get part number.  FZ31-9E, 11 pin, 7 position.  No luck finding one anywhere.  Anyone tried the 12 pin 8 position and if so, which position should not be used?