Eric Storz

David , what change controller would you recommend that I can run all 12 panels to? I’m running a 48volt system.
Thanks Eric

Sounds good, will see what I can find out.
I’m in golden valley AZ temperature here has hit 30 degrees once in last 3 years where I’m at.
I’m heading on vacation Saturday, will find information that I can before we leave. Will be back in AZ end of February. Get back to you soon. Thanks

Yes, we are completely off grid. Here is photos of my inverter and my charge controller. Also batteries I have.
I have 8 batteries will be wired in two sets of 4 to make 2 large batteries 48 volts each.
I do really appreciate all your help.
Thanks Eric

Jeff, the inverter is 10,000 watt 48volt output is 120volt no split. Not running any 240volt items..
Here is photo of back of panels. Also photos of the inverter box’s that came with panels.
Thanks for your help!!

Eric Storz wrote:

Jeff Bosch wrote:

Inverter wired to my shop 120volt breaker panel.

What does your inverter output?

It would be better if this was 240 split phase.

Jeff, the inverter is 10,000 to 120volt only. Not running any 240 voltage.
My charge controller has a 100 amp max

Jeff Bosch wrote:

Inverter wired to my shop 120volt breaker panel.

What does your inverter output?

It would be better if this was 240 split phase.

Jeff, the inverter is 10,000 to 120volt only. Not running any 240 voltage.
My charge controller has a 100 amp max

I’m new to this. I need to wire my system. This is what I have.
12 - 260 watt panels they came with change inverters , but don’t think I need them, I’m running power from panels to 100amp change controller.
Charge controller to 2- banks of 4 12volt 200ah battery wired to 48 volts. Batteries wired to 10,000 watt 48volt inverter.
Inverter wired to my shop 120volt breaker panel.

Second question to get most battery charging power from my 12 panels to my battery bank to I wire in seres or in parallel?
Hope someone can guide me on this.
Thanks thanks
I can add photos of parts if needed.