Anton Helsgaun

William Bronson wrote:Maybe this:Rapid Set


Rapid Set® CEMENT ALL®
SECTION 1 – PRODUCT AND COMPANY INFORMATION


Supplier
CTS Cement Manufacturing Corp. 11065 Knott Ave., Suite A Cypress, CA 90630, United States Telephone Number: 800-929-3030 FAX Number: 714-379-8270 Email: info@ctscement.com Website: www.ctscement.com
Supplier Emergency Contact
1-714-379-8260
Product Name: Rapid Set Cement All CAS Number: N/A
Chemical Family: Cementitious Mortar
SECTION 2 – COMPONENT INFORMATION
Ingredient (Specific Chemical Identity, Common Name)

Calcium Sulfoaluminate 40-60%
Cement Silica Sand 40-60%
NSodium Sulfate 0-4%
Methanol 0-0.1%


Available at Home Depot, relatively cheap.

Thank you, i will look for something like this in Denmark, but if there is none, do you know a homade castable?

So, a few days ago i asked a question about a charcoal making rocket stove, but my materilals werent suffecient so i got another idea from a youtube video:
I was planning on making one of these as they seem epic, but the burn chaber cant be made of steel as it will corrode away pretty quickly, So i does anyone know a good castable that transfers heat well? (btw i dont have acsess to fireclay, unless bentonite can be used)

Glenn Herbert wrote:Huh - I couldn't see any URL to fix. Thanks, Burra!

I think your scheme would work, though there are a few things I would change. First, there is no reason to have a front air intake; the top of the feed tube will do the job exactly right, with a variable lid like a couple of bricks that can be positioned to let the right amount of air in. That would also let you monitor the fire directly instead of squatting down, and then having to uncover the top releasing a plume of hot gases that might burst into flame. As long as your pipe is at least 6" and you don't have gigantic hands, you can reach in with a small scraper/scoop to clean any ashes when the system is cold. Ash will build up very slowly in an efficient combustion chamber like this.

The pipe in the burn chamber and lower riser, when well insulated, will corrode fairly soon, but as the pipe was free, all you will lose is your time to make it and replace it later. If you have a source of clay of any kind, you can form a layer of that around the pipe before insulating, and have some containment when the pipe falls apart.

The charcoaling zone looks good except for the wide flaring outer shell. I presume the material you have on hand is shaped like that, but it will let the heat dissipate around the top and reduce the charcoal making effectiveness. If you can get a sheet of metal with a hole in the middle for a lid, you should be able to keep the heat flow concentrated. Just arrange it so there is not a constriction smaller than anywhere else in the flow path.

Thank you very much for all the feedback! while my pipe is more like 4.5 inches, that doesnt matter so much as i have the smallest hand in the universe (bout 3.5 inches wide so itll do fine)
Then ill just remove nine and add a holed lid when i build it. Again, thank you for the feedback!

So, i recently heard rocket stoves are alot more effecient then a normal campfire. So i am use to making charcoal in a campfire but this is quite ineffecient (i use the "indirect" method, google it). So i made this sketch:


Will it work? any indeas on improvements? is it better for me to have an "L" rather then a "J"?


Thank you very much!