• Post Reply Bookmark Topic Watch Topic
  • New Topic
permaculture forums growies critters building homesteading energy monies kitchen purity ungarbage community wilderness fiber arts art permaculture artisans regional education skip experiences global resources cider press projects digital market permies.com pie forums private forums all forums
this forum made possible by our volunteer staff, including ...
master stewards:
  • Carla Burke
  • John F Dean
  • Timothy Norton
  • Nancy Reading
  • r ranson
  • Jay Angler
  • Pearl Sutton
stewards:
  • paul wheaton
  • Tereza Okava
  • AndrĂ©s Bernal
master gardeners:
  • Christopher Weeks
gardeners:
  • Jeremy VanGelder
  • M Ljin
  • Matt McSpadden

Oil Furnace Ran On Water Line 1950

 
Posts: 124
  • Likes 1
  • Mark post as helpful
  • send pies
    Number of slices to send:
    Optional 'thank-you' note:
  • Quote
  • Report post to moderator

Have you heard of the 1950 furnace conversion to water line? two service men in Texas about 1950 , had converted used oil furnace in motor pool to run on waste oil. Now, that's nothing new, but they added SS tubing so as the fire pot coil was heated first by oil flame. The fire pot was lined with fire brick insulation. The water line turned into steam, which turned into super heated steam at 1500 degrees.  At proper temperature, the oil line is shut off. The furnace nozzle continues to flame using converted hydrogen + oxygen torch. Furnace stays running. There is a shock wave produced from going from 90lbs pressure to AMBIENT - exiting nozzle. Dissociation of steam molecules to useful fuel. This normally takes about 3000-4000 degrees. They called in 2 technicians to help figure that out. The servicemen filed for US Patent . US Patent office issued paper Patent that only allowed 50% increase in furnace efficiency. ( They don't allow over unity!)  I read their complete application that stated fuel shut off. If water line shut off, the furnace cools off and has to be restarted on fuel oil. There was a T fitting with valves . The lower electric motor  had 2 shafts for 2 90lb. oil pumps.  A much smaller unit was built and taken to Washington , in Senator's underground garage. It was demonstrated in trunk of car. Unit looked like a fire brick chimney with circular pores holes in lower disc, like a propane stove.  (The Jackson Water Burner)     Put that in your pipe and smoke it!
 
Russ Rob
Posts: 124
  • Mark post as helpful
  • send pies
    Number of slices to send:
    Optional 'thank-you' note:
  • Quote
  • Report post to moderator


Nitrogen Hydroxide Fuel Aids Hydrogen Energy Content

Generated with regular low efficiency electrolysis ,when neutral air is pumped under the ions solution of electrolyte. Used in the Outback by Australian solders returning from WW2. They brought the data back with them after finding the Germans were experimenting with vehicle engines in motor pools. With no power lines in the back lands, the engines powering the generators would self run on this increased energy content fuel gases. Check it out. Nitrogen Hydroxide as an aid for Hydrogen + Oxygen water cells.

Archie Blue, retired engineer of New Zealand factory for electroplating of scissors, had, in the past, US Patent on discs cell of porous aluminum electrodes electrolysis cell with air pumped in from bottom. Dual type fuel gases evolve with the other increased efficiency of "clean sweep". Some of the neutral air wipes the stuck ions clean off , so as the maximum efficiency is achieved. He converted 3 cars to self run on water.40 amps draw from battery, alternator recharges.
 
Let me tell you a story about a man named Jed. He made this tiny ad:
Learn Permaculture through a little hard work
https://wheaton-labs.com/bootcamp
reply
    Bookmark Topic Watch Topic
  • New Topic