Got the
RMH up and operating now, and burning it while adding mass.
Hoping to dry it out a bit while building it so it wont take too long to dry out. Building on it once operational for the third day, we added mass to it. When it was first capped off with the barrel, it had a draft cold. It only smokes (if at all) for 5 seconds or so when it gets started, and I can probably stop that with technique. I noticed the draft slow down as we added wheelbarrow after wheelbarrow of
cob, but after that was fired for a bit and (I assume) dried out a bit against the ductwork, it runs hot now. When it was running while we added cob first, the barrel was 275 degrees, after a few days it was running at 475 on the side today. I'm guessing it will run a good bit hotter when dry. It was already too hot on the top for my
coffee . The WET mass is almost too hot to touch near the barrel, and pretty hot all over. It was steaming like mad today.
Also found a source for "amish"
soap to coat it with afterwards for waterproofing. Something like a pound for $2.50.
It is an 8 inch system with a firebrick riser and perlite insulation around it.
It is difficult to add cob to it without flipping little mud balls around with your kids who are helping.