I have two questions regarding rocket mass heaters. I saw YouTube video where they used barrels as the exit ductwork for the rocket mass here. The barrels were cutting half an butt it up into and then cobbed over. What are your thoughts on that kind of system?
Also I've noticed on much of the literature and when I watch your videos of Rocket mass heater building that the run of ductwork sort of goes in loop. What it work to do a straight run say and 18 for one run with one ductwork entire length?
Morgan Bowen : It looks a little like it was past your normal bed time when you posted this ! Can you make another try, perhaps after you have sketched it out for
ourself first? Its a little hard to follow ! Thanks !
Your Comments,Questions, are Solicited and Welcome ! A.L. !
Success has a Thousand Fathers , Failure is an Orphan
LOOK AT THE " SIMILAR THREADS " BELOW !
posted 6 years ago
Sorry for that last post. I am slowly going blind. I was using the voice recognition for the post. When I read it later later it felt little choppy to me too.
I will sketch what I'm thinking. And post it this afternoon after work.
Also, I will hunt down that YouTube video on the barrel ductwork that I saw.
The glass is neither half full or half empty. It is too big. But this tiny ad is just right:
permaculture bootcamp - learn permaculture through a little hard work