Adam - Here's one that we've liked, it's just a traditional mozzarella recipe, simple, but good and doesn't incorporate using a microwave as some people have caved into...
Traditional Mozzarella Recipe
Yield: About 1 pound of cheese
Ingredients:
• 1 gallon whole milk
• 1/4
tsp Thermo B (thermophilic starter culture)
• 3/4 tsp liquid rennet, diluted in 1/4 cup non-chlorinated
water
• Kosher salt without anti-caking agents (Diamond Crystal brand recommended) or cheese salt
Instructions:
1. Set out your milk an hour before getting started to bring closer to room temperature.
2. Slowly heat the milk to 95°F (see above instructions for doing this with a water bath setup) and turn off the heat source once that temperature is reached.
3. Sprinkle the Thermo B starter over the milk and allow it to rehydrate to 5 minutes. Then gently whisk the starter into the milk using an up and down motion. Cover the milk and maintain the temperature at 90°F to 95°F for 45 minutes.
4. Add the diluted rennet, whisking gently with the same up and down motion to distribute. Cover and rest again for 1 hour, keeping the temperature at 90°F to 95°F.
5. Once a clean break in the curd can be observed, cut the curds into 1/2″ pieces. Cover again and rest the curds for 30 minutes, maintaining the same temperature range.
6. Turn on the heat at a low setting and slowly raise the temperature of the curd mixture to 105°F, stirring occasionally to prevent the curds from clumping. Remove from the heat. Cover and rest for 15 minutes.
7. Transfer the curds to a colander lined with butter muslin or cheesecloth and drain 15 minutes. The curds
should meld into a lumpy block.
8. Check the temperature of the whey and heat to a range of 102°F to 105°F if necessary. Return the curd block to the whey, covering or wrapping as necessary to maintain the whey temperature. Rest the curd for up to 2 hours, checking the pH every 30 minutes until it reaches 4.9 to 5.2.
9. Remove the curd block from the whey, draining briefly, and slice into 1″ cubes. Transfer the cubes to a large stainless steel or other non-reactive bowl.
10. Heat the water from the water bath to a range of 170°F to 180°F. Sprinkle a few teaspoons of Kosher salt over the cheese cubes and pour in
enough hot water to cover the curds.
11. The heat will begin to melt the curds together. Wearing heat-resistant gloves, slightly knead the curds into a large ball while still submerged in the
hot water. Lift the ball out of the water and stretch into a long rope. Then fold the rope of cheese over itself a few times and return to the hot water. Repeat 2 to 3 times. When stretched, the curd should appear glossy and smooth.
12. While submerged in the hot water, divide the cheese into the amounts to be shaped. Work with one at a time to form into a tight, smooth ball, pulling the top outward and tucking the ends into the center of the ball. Once formed, place the shaped cheese into a bowl of ice water for 10 minutes. The finished cheese can be stored, refrigerated, in a light brine or sealed with a FoodSaver or similar sealing appliance.